The FlexKote System
Renew the roof you already own.
An acrylic co-polymer coating applied over your existing roof — re-coatable, renewable, and installed without shutting the building down.
- 01
Inspect & prep the existing roof
We walk every square foot, core-test where needed, and document the failures. Then the roof is cleaned, wet insulation is replaced, drainage is corrected, and seams, curbs, flashings, and penetrations are reinforced with fabric and mastic. Prep is where a coating job is won or lost.
- 02
Apply the FlexKote coating system
A seamless acrylic co-polymer top coat is applied in coats over the prepared surface. It bonds to most existing roofs — modified bitumen, single-ply, built-up, metal — with no tear-off. Your building stays open, and the bright white finish reflects heat instead of absorbing it.
- 03
Re-coat every renewal cycle
Coatings weather; they don't fail catastrophically. At the renewal cycle we clean and re-coat the surface, restoring membrane thickness and starting a fresh warranty term. Do this on schedule and the roof simply keeps going.
What it means for the building
Coating versus replacement, plainly.
| FlexKote coating | Full replacement | |
|---|---|---|
| Tear-off | None — coated in place | Entire roof removed |
| Building operations | Stay open throughout | Disruption, noise, debris |
| Landfill waste | Almost none | Tons of old roofing |
| Future cost | Re-coat cycle | Replace again in 15–20 years |
| Warranty | Renewable at each re-coat | One term, then it ends |
The renewal side of this is worth its own page — read how warranties renew.